Installation:Vinyl Top,75-80 MGB

Disclaimer: The following suggestions or instructions are done at the user's own risk and liability.WBCC take no responsiblities for any problems you may run into.If you are uncertain about the repair,consult an experienced auto top installer.

Tools and materials Needed:
           Pop Rivet Gun
           Drill and 1/8th" Drill bit
           Snap Installation Tool-Moss#386-980
           Snap Assembly Moss#227-108
           Phillips Screwdriver
           AWL,Box Cutter,Scissors
           White Chalk Marker

Tape Measure
Small Paint Brushes
1/8th"Rivets-Moss#325-288
Head Rail Rubber Seal-Moss#453-600
Contact Cement

Permatex-Bonds Leather & Vinyl to Metal

Also Very Good.

Step1-Pick a good warm day.Lay the new top out in the sun for about one hour.This will make it soft and pliable for stretching and fitting.

Step 2-Unlatch the two header rail clamps,all interior and exterior straps.

Step 3-Remove the metal anchor bar,rear of top,and set it aside.

Robbins Vinyl Top,Moss#242-655,Black W/Zip-out rear window